Payment & Shipping Terms:
|Power:||Electronic||Product Name:||Furniture Testing Equipment|
|Usage:||Pedestal Base Chairs With Casters||Model Number:||HD-F732|
|Speed:||Adjustale||Controller:||Setting The Test Parameters|
furniture testing equipment,
impact testing machine
Abrasion Resistance Furniture Testing Machines For Office Chair Castor
Applies to pedestal base chairs with casters, to evaluate the ability of the chair base and casters to withstand fatigue stresses and wear caused by moving the chair back and forth.
Controller buttons description:
1, Power:Turn on this switch to right “1”, the controller is on;
2, Start: Press it to start test;
3, Stop: Stop test;
4, Forward:Press this button, the machine will forward
5, Backward: Press this button, the machine will backward
6, Speed:Adjust the test speed;
7, Controller: Setting the test parameters
a) The chair or chair base shall be cycled 2,000 cycles over the obstacles as shown in
Figure 17b and then 98,000 cycles on a smooth, hard surface without obstacles.
b) Evaluate the product in accordance with the acceptance level in 188.8.131.52.
c) At the conclusion of cycling, a 22 N (5 lbf.) pull force shall be applied to each caster in
line with the caster stem centerline.
d) Evaluate the product in accordance with the acceptance level in 184.108.40.206.
There shall be no loss of serviceability.
Main technical parameters:
|Test standard||Bifma 5.1-Appendix C|
|Test speed||5 ～ 250 mm / min|
|Display mode||computer display|
|Control method||computer software control|
|Record||The peak value of the machine's force value is displayed, and the maximum damage value can be recorded|
|Power supply||AC / 220V, 10A, 50HZ|
|Machine size||(L x W x H) 1100x1100x1650 mm|
|Maximum test sample||width 800mm|
|Configuration function||The whole machine has an abnormal alarm function|
|Main accessories||6 height blocks for chair feet, 1 base block, 1 auxiliary fixture.|
Contact Person: salesmanager
Framework: 1 framework with traverse member and base plat 1200mm ×1200 mm , 12mm thick, galvanized steel
Rotation test axis: 1 electromotive test axis for the rotation of the turning knob, position-controlled, rotation angle +/- 360°
Pneumatic test axis: 1 pneumatic test axis for seat, load controlled, position diameter 80mm, stroke 500mm
Number and Cycles: Can be set by PLC ( 0- 99,999)